Premium PU Repair L.E. 3,5

Low hazardous, fast curing structural 2-part polyurethane adhesive specially designed for small, quick, durable bonding and repairs on plastics and many other substrates.


Category

Description

Not H351 classified –low hazardous, not carcinogenic
Bonds most plastics, metals, wood, etc. –universal
3.5 minutes open time –longer working time
Excellent filling properties –doesn’t sag while curing
Doesn’t bubble while curing –neat finish
Doesn’t peel off –easy sanding
Very good flexibility –doesn’t crack
Ultra small mixing nozzles –less waste of product

Additional information
Color Black
Content 50 ml

Application

Premium PU Repair LE 3.5 allows small repairs to be made in a very limited time, such as filling small cracks, holes and scratches, but also small assembly operations. Bonds most plastics, metals, wood, etc.

Manuals

1. Clean repair area with KENT Acrysol or Soft Surface Cleaner and allow to dry.
2. Using 80 grit wet / dry disc, sand both the surrounding areas of the repair.
3. Re-clean repair areas with KENT Acrysol or Soft Surface Cleaner and allow to dry.
4. For more difficult-to-bond plastics, apply KENT Plastic Adhesion Promoter in several thin cross layers to both sides of the repair and allow to dry.
5. Place the opened cartridge in the dispenser and purge until material starts to flow from both cartridge chambers. Fit the supplied mixer tip to the cartridge, extrude and dispose of first 2 – 3 cm of product then directly proceed with the repair. The material in the mixer will become very difficult or impossible to dispense at about 2 minutes after starting to extrude, in which case a new mixer tip should be used.For a scratch or crack repair, spread the bead over the scratch or the crack within 3 minutes respecting a thickness of max. 3 – 4 mm. The thinner the layer, the slower the product will cure.
6. For an assembly operation, bring both components together and apply uniform pressure within 3 minutes. Clamping time is approx.10 minutes at 23°C, after which a tensile strength of 1.5/Nmm²
7. After 30 – 40 minutes, depending on temperature, sand the repair area to a smooth finish if required. Avoid excessive speed, care must be taken not to overheat the plastic.
8. Allow 1 hour at 23°C between product application and painting. More waiting time is needed at lower temperatures.
9. Uncured material may be removed from tools and equipment with KENT Acrysol. Within the first hour, the repair can be removed by peeling it off. Once fully cured, it’s almost impossible to remove.

Your challenge – our solutions

Improve & Protect

Additives
Lubricants

More info

Bond & Seal

Bond & Seal

Adhesives
Sealants
Adhesive tapes

More info

Color & Coat

Color & Coat

Levelling compounds
Primers
Fillers
Coatings
Paints

More info

Clean & Care

Cleaners
Polishes & Sealants
Care products
Disinfection & Odour remover

More info

Apply & Equip

Apply & Equip

Accessories
Equipment
Consumables

More info