one2K Clear Coat
A crystal clear, extremely durable, chip and UV-resistant coating
Description
- Ready-to-use 2K technology – no activation required
- Unlimited pot life – can be reused at any time, no waste of material
- Extremely durable – chemical, UV and scratch resistant
- Wide field of applications – OEM finish, old paints, bare aluminum, bare and galvanized steel, wood
- High and hard dry film thickness – great polishability
- Forms a deep and shiny surface – no risk of dripping
Additional information
| Content | 400 ml |
|---|
Application
KENT’s one2K Clear Coat, formerly 2K Crystal Clear, is a two-component polyurethane clear coat that forms a chip and UV-resistant film which is not only resistant to chemicals but can also be used on a wide variety of surfaces, such as water-borne and solvent-borne paints, bare aluminium, bare and galvanized steel, and wood.
Its high film thickness, durability and excellent polishability make the one2K Clear Coat the product of choice when it comes to partial paint jobs or spot repair. Thanks to its special formulation the one2K Clear Coat provides an instant deep and high-gloss OEM-level finish without material run-off.
The one2K Clear Coat is a ready-to-use product that does not require activation. Once the actuator is pressed, the emerging material will react with the ambient humidity. We recommend checking that the relative humidity is within 35 – 85% before application, as this is decisive for the reactivity of the product. A simple hygrometer is perfectly adequate.
Spare nozzles available: 86988 (standard) und 86986 (fine)
Instructions
- The aerosol should be at room temperature.
- Shake the can for 3 minutes.
- Test the spray pattern on another surface.
- Apply cross-wise in 2 – 3 thin layers. Keep a distance of 15 – 25 cm to the surface to be treated. Allow it to dry for about 5 minutes between each application.
- Final flash-off: 30 minutes
- Drying time: 30 minutes at 60 °C, 12 hours at 20 °C or specific IR drying
- After use, turn can upside down and spray for approx. 5 seconds to clean the valve.
Your challenge – our solutions
