Anaerobic Activator

Solvent-based activator for increasing the cure speed of anaerobic adhesives


Category

Description

Speeds up cure time –for faster return to service
NSF K1 registered –for use in food-processing environment

Additional information
Color Transparent
Content 200 ml

Application

Anaerobic Activator is especially recommended to accelerate the cure of anaerobic adhesives, on active and passive metals (see table on page 2).
It can also be used to accelerate the cure in larger bond gaps and deeper threads, or on cold parts.
As it’s a solvent-based formula, Anaerobic Activator also features good cleaning properties.

Manuals

1. Apply KENT Anaerobic Activator on all metal parts to be assembled and allow 30 to 60 seconds to dry.
2. Assemble parts immediately using the KENT anaerobic adhesive which is required for the application, referring to the relevant product technical data sheet.
3. The time needed to reach initial strength will be reduced to approx. 20 to 120 seconds and varies depending on the type of anaerobic adhesive and the application conditions (temperature, nature of the surfaces to be bonded, thread size, gap size, etc.)
NB: the solvent can affect certain surfaces like plastics and coatings. It is recommended to check compatibility before use.

Your challenge – our solutions

Improve & Protect

Additives
Lubricants

More info

Bond & Seal

Bond & Seal

Adhesives
Sealants
Adhesive tapes

More info

Color & Coat

Color & Coat

Levelling compounds
Primers
Fillers
Coatings
Paints

More info

Clean & Care

Cleaners
Polishes & Sealants
Care products
Disinfection & Odour remover

More info

Apply & Equip

Apply & Equip

Accessories
Equipment
Consumables

More info