Advanced Plastic Repair 5 Min

A universal 2K polyurethane adhesive suitable for the body shop industry. Will enable its user to make quick and easy repairs on most plastics.


Category

Description

Universal adhesive –one adhesive for all types of plastic
50ml cartridges allow two average-sized repairs –cost effective repairs
Cures within 15-20 minutes –allows quick through put in workshop
Over paintable with any standard paint system –compatible with all paint systems
Works over wide temperature range –can be used in all conditions

Additional information
Color Amber transparent White
Content 50 ml

Application

Advanced Plastic Repair has been formulated for the repair of most types of plastics, including repairing of splits, or replacing missing pieces in all damaged plastics such as grilles, door mirrors, spoilers, skirts headlamp casings, fan shrouds and ducting.
It can also be used as a two-pack fast cure adhesive for bonding together broken plastics such as lugs and mounting brackets. It fills holes, tears and joints in metal, wood, stone, concrete and glass & window metal frame manufacturing for bonding corner angles.

Manuals

1. Ensure surface is clean using KENT Acrysol or Soft Surface Cleaner.
2. Using 80 grit wet/dry disc sand both the surrounding areas of the repair. Re-clean using KENT Acrysol or Soft Surface Cleaner.
3. Apply Kent Plastic Adhesion Promoter to both sides of the repair and allow to dry.
4. Balance the cartridge before fitting the mixer tip to the cartridge, extrude and dispose of first 2-3 cm of product. Then apply a bead of Advanced Plastic Repair onto one surface of the repair area.
5. Bring both components together within the open time and apply uniform pressure to spread product evenly over repair so product extrudes from repair area.
6. If required, apply additional adhesive to the surrounding area to provide extra strength to the repair.
7. Hold the component in final required position for a minimum of 1 minute.
8. After 10-15 minutes (at 20°C) sand the repair area to a smooth finish if required. Avoid excessive speed, care must be taken not to overheat the plastic.
9. Allow 1 hour at 20°C between product application and painting.
N.B.: Uncured material may be removed from tools and equipment with a suitable cleaner. Once cured the adhesive must be removed mechanically.

Your challenge – our solutions

Improve & Protect

Additives
Lubricants

More info

Bond & Seal

Bond & Seal

Adhesives
Sealants
Adhesive tapes

More info

Color & Coat

Color & Coat

Levelling compounds
Primers
Fillers
Coatings
Paints

More info

Clean & Care

Cleaners
Polishes & Sealants
Care products
Disinfection & Odour remover

More info

Apply & Equip

Apply & Equip

Accessories
Equipment
Consumables

More info